|
||
|
||
|
SPECIFICATIONS:
Line Direction: Right-to-Left
CONSISTING OF:
L-Type Coil Car:
52" Wide Deck
40" Centerline of "V" to Side Mast Allowing for an
80" O.D. Coil
9" Dia. x 27" Long Lift Cylinder Body
Approx. 15" from Floor to Bottom of "V" Cradle
Self-Contained Hydraulic Power Unit
DELTA Cone Type Uncoiler:
Solid Non-Expanding Mandrels
Sliding Bases
Wichita Brake on Both Mandrels
45" from Centerline of Mandrel to Base
Feedup Drive, Renold WormMaster 60:1 Reducer and
Motor
Wichita Clutch
DELTA Entry Unit:
Fully Articulating Peeler Table Pivots Up and
Down and Extends
10" Dia. x 78" Face Pinch Rolls
DELTA Straightener:
9 Work Rolls
10" Dia. x 78" Face Rolls
4 Over 5 Roll Configuration
(1) Set of 14.5" Wide Backup Rolls on Center
of Work Rolls
DELTA Leveler:
19 Work Rolls
2.5 Dia. x 78" Face Work Rolls
9 Over 10 Roll Configuration
(5) Adjustable Flights of Backup Rolls (Cam Type)
Straightener and Leveler Share the Same Drive Train:
.500" Gauge x 72" Wide Mild Steel
100 HP
0 to 100 FPM Line Speed
Side Guides
STAMCO Double-Stube Edge Trimming Unit:
Eccentric Adjustment
125 HP DC, 500 V, 1750 RPM, 203 Amps
102 HP Horsburgh & Scott Reducer, 1.0 Ratio
Scrap Chopper:
Paddle Type
(1) Set of Choppers for Each Side
DELTA Model SS-652-000 Shear:
.500" Gauge Max. x 72" Wide Mild Steel
Single Rake Design
Down Acting
Entry and Exit Driven Pinch Rolls
66" Pass Height
75 HP, 230V
(2) Runout Tables:
40' Long
On Rails
Operators Console
145 KVA Isolation Transformer
CONDITION: Installed
RETURN
to our home page