|
||
|
||
|
CONSISTING OF:
30,000 Lb CINCINNATI Uncoiler:\
60" Mandrel Face
16" to 20" I.D.
72" O.D.
Full Length Holddown Roll
Slide Base
Wichita Brake
50" Floor to Center of Mandrel
Entry Unit:
Peeler Table
Pinch Rolls
Side Guides
Crop Shear
Slitter Head:
Drop-In Type Slitter Head, Single Eccentric Design
7.5" Dia. x 55.5" Arbor Face Slitter:
Model GII 7.5x52 L
Comes with (3) Sets of Shimmed Tooling and Knives
Approximately 11.75" O.D. and 12.25" O.D.
100 HP DC Slitter Drive, 500 V, 850/255 RPM with
Drive (TBD) Gearbox Rated at 125 HP,
3.38:1 Ratio, 1750 RPM Input, 520 RPM Output,
Serv. Factor 1
13" W x 44" Dia. Spool Oscillating Scrap Winder:
Rear Discharge / Dump
Pit Cross Over Table
Drag Board Tension Stand:
60" Face
Separator Tooling Bar with Set of Separator Spacer
Tooling and Discs
20,000 Lb. x 56" Recoiler:
16" I.D. with Pads for 20"
40" C/L of Mandrel to Floor
75 HP DC Motor, 500 V, 850/2000 RPM to a
Turner Uni-Drive 2:1 and 1:1 Ratios and
20.93:1 Ratio to a Loopco Reducer,
650/1950 RPM Input, 31.3/93.9 Output
20,000 Lb. Coil Car:
40" Wide Deck with Extension Beyond
33" C/L of "V" to Side Mast
Removed and In Storage
RETURN
to our home page