|
||
![]() |
![]() |
SPECIFICATIONS:
Capacity: 30,000 Lbs.
Line Direction: Left to Right
CONSISTING OF:
30,000 Lb. LOOPCO Entry Coil Car:
48" Wide "V" Cradle
Removable 9" High Riser
Above Floor Type
Self-Contained Hydraulics
Pendant Control
30,000 Lb. x 53" LOOPCO Uncoiler:
16" to 20" I.D., To 24" With Pads
Hydraulic Expansion
Four-Segment Mandrel
Powered Holddown Arm
Sliding Base
Wichita Water-Cooled Brake
2 HP AC Threading Drive With Air Clutch
Approx. 39.5" Passline From Floor To Center
Of Mandrel
LOOPCO Combination Peeler / Holddown:
Hydraulic Up / Down, In / Out Peeler
Powered Holddown Roll
7.5" Diameter x 50 Arbors BRANER Turret Slitter Head:
(2) Heads
Entry Pinch Rolls
Entry Side Guides, Manual Adjustment
15 HP AC, 230/460 Volt, 1750 RPM
(2) PAXSON Scrap Winders:
Oscillate Wind
Powered Scrap Dump
LOOPCO Recoiler:
20" Dia. x 58" Face Drum
Manual Clamp & Expansion
Hydraulic Push-Off
Overarm Separator
75 HP DC Reliance, 500 Volt, 650/1950 RPM,
With Blower
H & S 2-Speed Gearbox, 13.75:1 & 41.0:1 Ratios
Hydraulic Power Unit
RANGER 2-Arm Turnstile:
30,000 Lb. Capacity Per Arm
61" Long Arms
With Push-Off
Powered Rotation
C-Hook Slot in Arm With C-Hook
(NOTE: Turnstile Main Shaft Is Missing)
Down Layer:
60" O.D. Capacity
In-Line Discharge
Non-Powered Conveyor Rolls
Large Quantity Of Knives & Tooling:
Hydraulic Power Units
Main Operator's Control Panel
Main Electrical Cabinet
Removed & In Storage
RETURN
to complete inventory display
RETURN
to our home page